3M 1080 Carbon Vinyl Wrap Interior Trim

I have vinyl wrapped my ugly interior trim pieces, Using the 3m Carbon vinyl.
Looks 100% better in my opinion. I bought a roll of the vinyl, So if your in Sydney i can remove your trim bits and do the same on your Gen 2 for a small fee if you like.
PM me for details...
Im thinking of doing my roof in the Matt black so i might be able to offer this in the future too if anyone is interested.
Here is a couple of pics of the trim.
Sorry for the phone pics! I think it looks alot better in person and will try get some better pics up.

nice work mate looks awesome :2thumb:

Very awesome, should have come from factory like that.

Nothing wrong with a bit of CF good work!

How hard would it be to do my centre caps and leave the Mazda logo as silver? :( the paint paint has started to flake off :(

Much better than what they come with, actually anything would be better.

Now for the door trims.

Nice job.

Well done seaton, i had done my internal door handles for protection as the silver was being scratched by rings and constant use . Same stuff .

That looks awesome Cton.

How difficult was it to remove those two bits of trim?

Those trim pieces pop out :) there easy

Here is my attempt on my interior with some di-noc a few months ago, there are a few bits that I need to fix up (also did the window switches but forgot to take pics). Anyone planning on DIYing this stuff, a heat gun, a very sharp scalpel and a lot of patience are essential in getting the film to comply with some of the complex curves etc.

http://i546.photobucket.com/albums/h...3/IMG_1104.jpg


http://i546.photobucket.com/albums/h...3/IMG_1105.jpg


http://i546.photobucket.com/albums/h...3/IMG_1108.jpg

Nice Matt,u obviously have too much time on your hands.

Here's my centre console.

(Note - My vinyl lines up) :p

http://i363.photobucket.com/albums/o...y/IMAG0185.jpg

http://i363.photobucket.com/albums/o...y/IMAG0189.jpg