Hey all. I installed my corksport sri today. here are my thoughts on the process...
I am not a mechanic by any means. Except for car stereos i have no experience in modding cars. I have learned everything i know about turbo engines and performance mods by being a part of ozmpsclub. thanks everyone.
Engine mods on my 07 MPS3 prior to install:
Turbosmart dual port BOV
CPE rear engine mount 60d
2XS short shift plate
My car this morning
All the bits i took out... stock airbox, battery and stock TIP. The battery conpartment is out drying... thought id wash it out after descovering quite a bit of dirt under the battery... im guessing it got there through the vent from the bonnet scoops?
The instructions didnt mention taking off the hose from the crank (or something) which i found easy to do using a couple of skinney allen keys to undo the clips.
The empty space where it all came from.
Parts to install
TIP in! was fairly easy though the hose going from the pipe to the crank thingy was pain... i could only get it on most of the way... but it aint going anywhere.
Also had to trim the stock hose from the BOV on the TIP end... there was a slight curve in it which wouldnt allow it to go on far enough to let it get back on the BOV.
continued on following post...