Hey guys!
I just installed a set of HPX pads with code DB1661HPX ( can anyone clarify these are the correct pads for MPS3 Front)?. The reason i ask is because, the pad is not sitting on the disc correctly.. About 8mm of the outer edge of the rotor is not in contact with the pad..... whereas the the inside of the rotor which is "greyed out" is in contact with the pad.. So essentially the pad is sitting approx 8mm towards the centre bore more then it should.
Please dont tell me this is normal. Because then my disc would eventually have a lip the size of 8mm?!
---------- Post added at 11:29 PM ---------- Previous post was at 10:55 PM ----------
More pictures of how the pad does not sit correctly.