Hi All, I ordered new slim line plates in an effort to reduce the "mole on nose" effect the number plate holder does to the front bumper.
Before I removed the number plate holder it seemed there were only 2 rivots that held it too the bumper.
Only after drilling out the rivots did i discover that there are 2 extra "guide plugs" that probably assist in placement while it's being fitted in the factory.
My plan was to mount the new slim line plates flat against the bumper with a downward facing angle, but as the 2 big holes are so high on the bumper I had to change plans and mount the plates higher so I can cover them. See Photos below.
The end result is better than it was, but still a bit bummed about the holes.
My question, to the trademan skilled in panel beating, can a workshop bog those holes and respray?
I know it's a fine detail and most people wouldn't care, but it's a car thing I guess.
Any advice welcome!