hi guys and girls,
i just installed a new ETS TMIC on my Gen 1 MPS 3, every things was fine during the installation, but when i try to close the bonnet, it was hard to close, is this normal???
Cheers
hi guys and girls,
i just installed a new ETS TMIC on my Gen 1 MPS 3, every things was fine during the installation, but when i try to close the bonnet, it was hard to close, is this normal???
Cheers
I've heard that the 3.5" rubs on the shroud. I'd recheck that I have everything installed correctly and if it's still an issue ask the supplier.
Should not affect your ability to close the bonnet. Should close as normal.....
Wasn't an aftermarket engine mount required to stop rubbing on the TMIC or was that the 3.5" variant?
i would say an engine mount would be the first mod anyways, it was mainly for the 3.5" to stop it from knocking the firewall
remove it all again and put it back on, it should fit without issues
thanks for input everyone
the TMIC is 3.25", i took it out and reinstall it agian, every thing is fine,
but i find out it wasn't the IC holding the bonnet up, is the plate around the IC,
is there anyone has the same problem???
Cheers
ETS had a bad run a while ago.. mounts were welded at the incorrect angles. Resulting in the shroud (and the whole IC) sitting up a bit higher.. thus compressing the rubber skirt on bonnet closure. It will be the fwd mounting bracket. I heated it up and bent it (so it does not crack) forward by about 5-7mm. ETS have addressed this issue, So i assume you either have a second hand IC, or it the mount has been bent during shipping.
untill you fix it.. just remove the shroud. That is assuming you dont have a welded one...
its a simple fix.. good luck mate
Doc
^^
correct.. this is just an interim measure...
Remove the whole TMIC, and with caution.. bend the fwd leg towards the TMIC itself.. (ie upwards)...
only say 5mm
this should then allow everything to sit correctly..
Best of luck
Doc
just keep adjusting it.. maybe your read mounts are out of whack as well.. took me a couple of goes..
if you leave you rubber skirt loaded to the heck.. it will rub on the shorud, and will quickly fall appart
what do you mean mate?
The rear mount may just need to be adjusted a little.. bend it towards the IC..
it locates on the rear IC mount.. just rear of the rocker cover. Make sure you use the top hat bush and rubber grommet.
Doc