I was looking at a similar style with the red rim in the inner rim but only comes in 17" rims at Bob Jane Chermside. Thinking about it because I can buy the used racing tyres off the Grand Prix race car for days out at Qld Raceway..... I haven't priced them yet yet to decide.
products
think these would look any good?
i think so.
black with green lip dave weve already covered this
there has to be some chrome......come on Lynchy I'm skool....CHROME
Hmmm *googles rims*
don't start as I will spend $$$$
back with green lip will look hot dave
I just have to find the right rim and with a green rim...
Enkei RPF1, forged and lightweight (7kgs per wheel )
Ditto :-) I think you'll find they are a high-tech MAT cast process, not forged...but they match forged wheels in strength.
But they are awesomely light and strong, I believe that's also due to the geometry of the wheel design - double lip with shorter spokes and the cylindrical inner lip adding rigidity. equalateral triangles and paralell spokes also add rigidity. It's a function over form design.
Last edited by Nexus; 31-08-2009 at 09:33 PM.
Enkei RS+M 17" on my cosmic blue MPS3.
Any reason y u went for a smaller size wyvernone?
I wanted a more road-compliant softer ride and lighter tyre/rim. The entire wheel (with tyre) is now 4kg lighter than the stock wheel. Also a benefit is the lower cost of the tyres (215/50/17).
Started with these RX-8 rims:
...then these XHP Jet Blacks (decided I didn't like the look - too plain):
...the latest evolution involved going back to the RX-8 rims and painting them a dark metallic grey. The rims looks black in the photos but are in fact quite a bit lighter. Very happy with this look, but v disappointed about the stone chips appearing on them already No more rally-style driving on the gravel roads around the farm; have to keep it under 30km/h on unsealed roads to prevent more chipping...
Buddyclub P1 Qf Ultra lightweight (4.6kg) 15x7 +35 Yokahama C drive tyres
Some other rims I have sitting around.