This is specific to CES SRI and heatsheild, but, can be adapted to suit any SRI.
Tools required:
10mm Socket.
12mm Socket.
Philips head screwdriver.
Flat blade screwdriver.
Allen keys.
Allow your self around 30 minutes to fit.
Removal of the stock airbox
Pop the bonnet.
Disconnect the negative battery terminal.
Disconnect the MAF sensor. (plug)
Remove the MAF sensor. (2x philips head screws, replace into stock airbox)
Undo airbox to turbo pipe. (10mm socket)
Unclip and remove airbox lid. (4 clips)
Remove air filter.
Remove airbox base. (jiggle upwards)
Remove airbox bracket. (2x 12mm bolts - gold colour)
Removal complete.
Installation:
Fit heatsheild - front first then lower the back.
Attach the heatsheild. (rear bolt - located only, front bolt - tight)
Fit SRI to bracket. (2x6mm bolts - supplied)
Fit bracket to rear. (12mm bolt - tight)
Fit filter. (tight)
Tighten clamp on turbo pipe to SRI.
Clean MAF sensor - if required. (recommended)
Fit MAF sensor to SRI. (4mm Allen bolts - supplied)
DO NOT OVER TIGHTEN
Reconnect MAF sensor plug.
Fit lid. (3x 4mm bolts - supplied)
Position lid and attach to plastic above headlight. (2x 4mm screws)
Reconnect battery.
Start the car and test drive - sensibly, no tickets please.