Hi All,

Just planning some mods for the not-too-distant future for my MPS6.

I LOVE this gauge pod for the map compartment Mearcat Auto Accessories

I want a boost gauge (fairly simple) as well as oil pressure and water temp. The one's on MPS garage look great. What is involved in installing the sender units for the water temp and oil pressure?

Cheers,

Thomas

---------- Post added at 09:08 PM ---------- Previous post was at 06:34 PM ----------

So I worked out that for oil pressure I can either replace the oil warning sender completely or use a t-piece. Is that right?

Water temp I can do the same/similar?