Parts on the bench for assembly testing
ATX power hardware on far left = 12V automotive power supply, ATX hardware on far right is ATX power watchdog
In the middle we have RaspberryPi compute module 4 on CM4 I/o board with various HDMI and USB plugged in
USB3 daughterboard to the left of that.
Couple of cables to create, will then test and configure power supply and accessory/ignition on response.
A few PCB standoffs and case mods will be necessary.
I am considering placing the unit behind the back seat where there is two spaces for a pair of 30 amp hour deep cycle batteries…currently there’s only a single battery in place.
Sent from my iPhone using Tapatalk
"Blue Meanie" 2007 Aurora Blue MPS 3 - 18x8.5+44 SSR GTX01 - 235/40R18 Michelin PS5 - 3.5" ETS TMIC - CPE stg 2 mount - HKS/CPE BPV - 2XS inlet - 2XS short shift - Corksport turbo manifold - HT 98 octane tune - Leather/Aluminium handbrake - Momo shifty knob - 7" touchscreen - JDM Mazda Retractable dashtop screen assembly - Bespoke Raspberry Pi Android based GPS/Carplay and instrumentation - 36AH reserve battery and C-TEK isolator - TEIN Street Advanced coilovers 1" drop - Superpro bushings - 220Kw/410Nm.
"Lipstick" 2013 Velocity Red MPS 3 - 18x7.5+48 Enkei RPF1 -225/40R18 Federal RS-RR - CPE TMIC - COBB inlet - CPE stg 2 mount - COBB Stage 1 98 octane tune - COBB shifty knob - 2XS short shift - 2XS turbo manifold.