VersaTune is proud to announce the immediate availability of VersaTuner 1.10.0

The update includes these changes:
All Platforms

  • Data logging over Bluetooth (beta) - no more wires above your feet. Pair an OBDLink LX or MX interface and use the dashboard, record data logs, read and clear DTCs wirelessly at speeds of up to 50 data points per second. In fact, generic ELM327 based adapters are supported, too, but might offer lower logging rates or not work for some operations.
  • "Expert" mode in the Tune Editor that allows overriding the safe value range checks. If you are running a high power setup and need to take it to the extreme, you can use it to enter ANY value in ANY cell of ANY table, limited just by the internal code of the ECU. Please note that this feature is for advanced users only and you take the full responsibility for any side effects caused by the use of it.
  • Dashboard enhancements:
    • Log up to 16 parameters simultaneously
    • The computer will not sleep or go on standby for the entire duration of the logging session

  • Values in logs exported to CSV are now rounded properly, so they are short and easy to look at.
  • Possibility to copy the code and description of the DTC
  • New installer that installs VersaTuner into per-user locations, so multiple Windows users on the same PC can now install and use VersaTuner without any clashes of files or data.
  • Minor usability improvements of the Tune Editor.



Mazdaspeed6/Mazda6 MPS, Mazdaspeed3/Mazda3 MPS, Mazda CX-7

  • New parameters that you all have been waiting for:
    • Boost pressure
    • Injector duty cycle

  • Maximum Spark Timing Table



Bug fixes

  • Fixed a bug that did not allow exporting CSV files on some locales.
  • Multiple other bug fixes and improvements