User Tag List

Results 1 to 13 of 13

Thread: Rayd's Big Power Parts Sale - GTX3071, CPe Ex. Mani, Forged Long Block etc

  1. #1

    Default Rayd's Big Power Parts Sale - GTX3071, CPe Ex. Mani, Forged Long Block etc

    Item:
    GTX3071 ATP Mazda Flanged rear housing - Ceramic coated rear housing to suit EWG
    Location: Parramatta area
    Item Condition: SOLD
    Reason for selling: SOLD
    Price and price conditions: SOLD
    Extra Info: This awesome turbo was used on my MPS 6 for about 25000kms, no shaft play at all, has been ceramic coated since day one of install, running perfectly when taken out - Never tracked - Comes with custom made Braided Coolant feed line
    Pictures: SOLD



    Item: CPe Mazda flanged Exhaust Manifold - All Completely ceramic coated
    Location: Parramatta area
    Item Condition: Great
    Reason for selling: SOLD
    Price and price conditions: SOLD
    Extra Info: SOLD
    Pictures: SOLD


    Item: Tial 38mm EWG 2 bolt flange
    Location: Parramatta area
    Item Condition: Good
    Reason for selling: SOLD
    Price and price conditions: SOLD
    Extra Info: SOLD
    Pictures:


    Item: 4” Full HTP Intake - TIP + MAF housing with air straightener + AEM Dry Flow Air Filter (new)
    Location: Parramatta area
    Item Condition: SOLD
    Reason for selling: SOLD
    Price and price conditions: SOLD
    Extra Info: SOLD
    Pictures: SOLD


    Item: ETS 3.25” Top Mount Intercooler - Hot side modded to have 2” entry and built in boost tap, perfect for any Garret turbo but can also fit OEM.
    Location: Parramatta
    Item Condition: SOLD
    Reason for selling: SOLD
    Price and price conditions: SOLD
    Extra Info: SOLD
    Pictures: SOLD


    Item: Stratified Boost Dial
    Location: Parramatta area
    Item Condition: SOLD
    Reason for selling: No longer required
    Price and price conditions: SOLD
    Extra Info: SOLD
    Pictures: SOLD



    Item: Perrin 3 port EBCS
    Location: Parramatta area
    Item Condition: SOLD
    Reason for selling: SOLD
    Price and price conditions: SOLD
    Extra Info: SOLDPictures: SOLD


    Item: Denso ITV22 iridium 1 step colder spark plugs
    Location: Parramatta area
    Item Condition: NEW
    Reason for selling: Ordered or customers who didn’t pay
    Price and price conditions: $85 per set shipping included
    Extra Info: When boost gets turned up in these motors so does combustion temperatures, this means that the OEM spark plugs are operating out of there efficiency range and may promote engine detonation or pre-ignition and hence will cause a higher amount of Knock Retard on your MPS, especially when driven hard.
    Hence you move to one step colder plugs which can more effectively battle these higher combustion temps by staying ‘colder’ and help battle KR!
    Pictures:



    Item: Slot reserved for Spec stage 3+ Clutch
    Location: Parramatta area
    Item Condition: Used - 45000kms
    Reason for selling: Need more torque clamp capacity
    Price and price conditions: $TBA - To be swapped out and available in a couple months
    Extra Info: This clutch is one of the best clutches for balanced performance and drivability, great pedal feel maybe 25% harder than OEM pedal feel but still maintains a massive 650Nm torque capacity.
    I’ve taken good care of this clutch, Has never slipped, Maybe launched 3-4 times in its life time, never tracked, never abused.
    Pictures:
    Soon to be uploaded


    Item: Slot reserved for Fidanza lightweight Billet Aluminium Flywheel
    Location: Parramatta area
    Item Condition: Great
    Reason for selling: Does not mate up to my heavy duty clutch kit
    Price and price conditions: $TBA - To be swapped out and available in a couple months
    Extra Info: This flywheel is much lighter than the OEM dual mass, 11lbs vs 22lbs. Removing this much UNSPRUNG mass means that your engine will rev faster, your turbo will spool quicker, your car will accelerate faster. It even has a removable friction plate which i will be replacing with a brand new plate once i pull it out.
    Pictures:
    Soon to be uploaded


    Item: Slot reserved for Forged MZR DISI 2.3L long block
    Location: Parramatta area
    Item Condition: 45000kms
    Reason for selling: Built New High Compression and custom spec long block
    Price and price conditions: $TBA - To be swapped and available in couple months
    Extra Info:
    Specs on the long block are as follows:
    Forged K1 Rods
    Forged 88mm Wiesco 9.5:1 Compression ratio 22.5mm wrist pin Pistons
    Clevite Main Bearings
    Clevite Rod Bearings
    ARP Crank Bolt
    ARP Main Studs
    ARP Head Studs
    Runs great - Compression tested recently @ 170psi across all cylinders
    Been a solid engine since it was built
    Very happily handle big power has been living around the 300kw/550Nm mark for most its life - Street driven, never tracked
    Will come as an assembled Long block - just need to bolt up your accessories like intake/ exhaust manifolds, HPFP, fuel rail and pulleys and you’re good to go
    Engine is fully swappable into any Mazda 3 MPS, 6 MPS, or CX7 if you’re that way inclined !
    Pictures:
    Soon to be uploaded




    Happy for pickup or shipping within Australia is also available


    thanks for looking!
    ~Ray
    Last edited by Rayd; 05-09-2014 at 07:01 PM.

  2. #2

    Default

    Item: Pedders Super Low Springs for Mazda 6 MPS / Mazda 6 N/A
    Location: Parramatta area
    Item Condition: Great
    Reason for selling: Moved to Coilovers
    Price and price conditions: $250
    Extra Info: Lowering Springs will drop the 6 MPS to potentially the most practical and nicest height you can achieve with a set of lowering springs.
    Pictures:


    Post reserved for future items
    Last edited by Rayd; 03-09-2014 at 09:30 PM.

  3. Default

    PM Sent

  4. #4

    Default

    PM sent

  5. #5

    Default

    interested in fidanza fly wheel

  6. #6
    Join Date
    May 2009
    Location
    Sunshine Coast Qld
    Posts
    749

    Default

    PM sent.

  7. #7

    Default

    Damn, if I had the $$!!

  8. #8
    Join Date
    Aug 2010
    Location
    West Pennant Hills, Sydney NSW
    Posts
    261

    Default

    PM sent

  9. #9
    Join Date
    May 2009
    Location
    Sunshine Coast Qld
    Posts
    749

    Default

    Cheers Rayd, received PM. All good.

  10. #10

    Default

    OP updated - Marked items that are sold

    CPe exhaust manifold - Tial EWG and Spark plugs still available.

  11. #11

    Default

    let me know when you are ready to part the flywheel and how much and we can go from there @Rayd

  12. #12

    Default

    bump

  13. Default

    Interested in cost for long block...EOI

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •