Hey guys, has anyone had issues installing there cobb rmm to realise that the bolt that goes threw the middle of the mount into the subframe is too big for the hole in the sleeve?
Im extremely dissapointed to say the least
Mitch
Senior Member
Cobb rmm wont bolt up!!!!
Hey guys, has anyone had issues installing there cobb rmm to realise that the bolt that goes threw the middle of the mount into the subframe is too big for the hole in the sleeve?
Im extremely dissapointed to say the least
Mitch
Stock as a Rock!
Are you using the replacement bolt they supply?
I installed this mount yesterday no dramas
Senior Member
They only supply a bolt with a hex key for the gearbox bracket end, you reuse the original bolt threw the main bush and into the subframe, however the hole for the bolt is undersized
Mitch
Can you take a measurement of the hole?
Sent from my Nexus 5 using Tapatalk
Senior Member
Its been sorted i got one from a bad batch that were drilled wrong, it happens.
How do you find the mount rayd? Does it vibrate alot?
@ Rayd would have installed it for someone else.Originally Posted by mymps11
Sent from my Nexus 5 using Tapatalk
--> 2008 Metro Grey Sports Pack Gen1 <--
CS SRI ll CS TIP ll CS AB ll 2XS SSP ll 2XS FMIC ll SURE Anchors ll Enkei RPF1's 17x9 +45 ll Lamin-X Fog Tint ll DBA T3 4000 series ll Remsa pads ll Braided lines
CP-E S2 RMM ll Hankook RS3 235/40/17 ll Forge V1 BPV ll Whiteline RSB ll AutoTech HPFP ll Spin-on Conversion ll Rear Diffuser
DGR Coilovers ll LED Replacement lights ll "08-MPS" plates ll Cobb AP V3 (E85) ll CP-e TBE ll OCC
Stock as a Rock!
Yeah I installed it for someone else but from the initial drive it does vibrate quite a bit more than stock but that's expected.
I'm assuming it will settle I after another 1000kms
Posting Permissions
Reply With Quote
GibbA