Hello,
Does anyone know where I can find a copy of the installation instructions for the CP-E TMIC for the Mazda 3 MPS 2012. Nothing on the CPe website...
Thanks
mps3er
Hello,
Does anyone know where I can find a copy of the installation instructions for the CP-E TMIC for the Mazda 3 MPS 2012. Nothing on the CPe website...
Thanks
mps3er
1. Undo 3 bolts holding TMIC on head of motor
2. Undo boost tube clamps on hot and cold side of intercooler
3. Undo BPV bolts and move aside (dont loose gasket)
4. Yank the stock TMIC intercooler off
5. Unbolt cold pipe and swap to CPe TMIC (don't forget gasket)
6. Ease the newly assembled CPe TMIC in position like an old man into a warm bath
7. Put back and tighten everything you took off in earlier steps
8. Win
Last edited by Rayd; 19-10-2013 at 03:51 PM.
where do those brackets that come with the core go ? lol
i'm sure i'll figure it out once new one's on there, but you know...better knowing it now i guess..
When I did mine I couldn't figure it out either. So I googled a picture of a TMIC and there is heaps of pictures already with the brackets on so you know when to put them.
Honestly once I saw where they went I couldn't figure out why I couldn't figure it out in the first place...
Just look and align things..
corksport has instructions if you need them...
not much difference between the 2
ah thanks. this is def helpful. i'll try use these tmw
with the cp-e the included brackets should be test fitted before being tightened (obviously) as its not like most that come pre-attached
haven't gone around to installing these yet, but i did manage to get hold of the CP-E TMIC instructions...
@Yeldarb - are those pics for the gen 1? the instructions seems to say the shroud won't be utilised for a gen 2 install...