Hey everyone,
So this is my first post, hopefully its in the right sections :s
Today i tried installing a Deceptor Pro II and a boost controller into my gen 1 3MPS, took me a while to do, but finally got all the hosing done, and all the wiring, everything was working fine. I came to take it for a spin, everything seemed okay, but when I got back, there was a weird smell. Popped the hood, and the hose sitting between the t piece to read the vacuum pressure for the boost controller had ripped/melted. turns out there was a lot of friction from the hose hitting the inside of the hood, which is probably leading to a fair bit of boost leak, which is a huge waste So does anyone know if theres a way to either rotate the top of the Deceptor pro II so that the nipple doesnt face directly up? Or has anyone else had any similar problems??
Cliffs
-Installed Deceptor Pro II and gforce2 parts today
-took car for a spin, started to wear away at one of the tubes
-need to know if I can rotate the top of the Deceptor Pro II top
Ive added a photo, although its not that clear
And thanks in advance for any info!!