Originally Posted by
Bakis
Hey guys and girls,
After approximately a year of slowly gathering parts and installing them, today the Downpipe arrived which is the last part for the turbo install to work.
Basically it's a Hi-Flowed k04 done by GCG Turbos so nothing over the top, apparently efficient enough to hit redline effectively and should be good for ~22psi, not that i'm aiming for that pressure.
Anyway just wanted to see if there were any little parts or special tools that i'd need to successfully complete a Turbo and Downpipe install?
I know with the BNR you need to extend the oil line, if i'm replacing with an OEM is that required?
How about special spanners and wrench's?
Thanks Guys!