wiring diagram

[Frankie3mps]

does anyone have the wiring diagram for our stock ecu?
the pin locations / what wire represents what....
getting the xede and the dummy harness soon and would like to cross reference with the stock ecu to make sure its all going to be right

[2XS]

I went down to my local Mazda and looked into the manual, It was about 30 pages of info just for the ECU, they didn't want to photocopy all those pages for me, so, I had to just get a couple. Hope you have better luck finding out more than I did. Maybe try a local tuner. I know APC here in Brisbane have done the XEDE on our cars and CT on the Gold Coast, maybe even try them. Good luck with your "Quest"

[mpsgarage]

It should come with the piggy back.

I would contact Xede directly.

I know for a fact after installing quite a few CPE Standbacks and PNP that you don't need to know anything about the wiring diagrams of the ECU because it's all taken care by the R&D CPE have done.

If Xede have done their R&D properly, they should be providing the same!

Can I ask why your going with the Xede over the Standback?

[Frankie3mps]

got it cheap...

[MattMPS3]

Attached is the ECU pinout from the Mazdaspeed 3 (should be identical), if you need the Xede wiring diagram, you can give Chiptorque a call and they will email it to you.