Hi guys.
I'm getting the Autotech internals in preperation for an AP OTS tune but I was wondering if it is safe to have the internals in and running prior to tuning?
Cheers
Hi guys.
I'm getting the Autotech internals in preperation for an AP OTS tune but I was wondering if it is safe to have the internals in and running prior to tuning?
Cheers
It's fine
All good mate!
Great. Cheers for the replies.
I'm getting my tyres done at Kmart Tyre and Auto soon - reckon it's safe to get them to do the internals while they're at it or get a recommendation for another mechanic?
I personally wouldn't go anywhere near kmart tyre and auto for tyres let alone installing fuel pump internals but that's just me. I did mine myself, however maybe a mechanic with a bit of experience with the MPS would be more reassuring.
I've actually found K-mart tyre and auto quite good to deal with, though maybe this is just because the one near my place is very nice.
The people are quite friendly and helpful, willing to fit you in, always seem to have pretty good prices etc, but i wouldn't go to them for installing fuel pump internals. There are plenty of how to guides, a few vids and tons of info on how to do it yourself...
Fair enough. Anyone got a recommendation for a mechanic/shop to install the internals in Canberra/ACT?
@SarcasticOne found any good mechanics in Canberra?
I believe "dyno tune" in belco installed @Jimbo 's fuel pump
They are one of the few places that have actually had done experience with an MPS, seen mine and jimbos... Am taking mine there next week for a service and an inspection, try to locate a sound at full throttle in upper rpm's...
Newbie FAQ My Build Thread
From stock, to GT3071, to substantially less modded, many lessons learned!
3" HTP | 100 Cel DP | Autotech HPFP | AP V3 - Self Tuned on E20 | JBR RSB | CPE S2 REM | JBR Shifter Bushings
Brilliant. Appreciate it lads. When it comes to fuel pumps on these things you can't be too careful. Once it arrives I'll give them a call and arrange an install.
Where did you buy them through? Could you please tell me, either here or in pm how much they cost + shipping?
Got them from Edge Autosport: Autotech Hi Volume Fuel Pump Upgrade HPFP Internals Mazdaspeed 3 6 MS3 MS6 for just under $400 shipped.
also @GoonBong there is a meet up next sunday if you're interested... a few of us nut cases getting together for a bit of a laugh/silliness over lunch
http://www.ozmpsclub.com/forum/cruis...ing-visit.html
Sounds good SarcasticOne. I'll double check I've got nothing on that day and might sound off in that thread. Cheers.
--> 2008 Metro Grey Sports Pack Gen1 <--
CS SRI ll CS TIP ll CS AB ll 2XS SSP ll 2XS FMIC ll SURE Anchors ll Enkei RPF1's 17x9 +45 ll Lamin-X Fog Tint ll DBA T3 4000 series ll Remsa pads ll Braided lines
CP-E S2 RMM ll Hankook RS3 235/40/17 ll Forge V1 BPV ll Whiteline RSB ll AutoTech HPFP ll Spin-on Conversion ll Rear Diffuser
DGR Coilovers ll LED Replacement lights ll "08-MPS" plates ll Cobb AP V3 (E85) ll CP-e TBE ll OCC
--> 2008 Metro Grey Sports Pack Gen1 <--
CS SRI ll CS TIP ll CS AB ll 2XS SSP ll 2XS FMIC ll SURE Anchors ll Enkei RPF1's 17x9 +45 ll Lamin-X Fog Tint ll DBA T3 4000 series ll Remsa pads ll Braided lines
CP-E S2 RMM ll Hankook RS3 235/40/17 ll Forge V1 BPV ll Whiteline RSB ll AutoTech HPFP ll Spin-on Conversion ll Rear Diffuser
DGR Coilovers ll LED Replacement lights ll "08-MPS" plates ll Cobb AP V3 (E85) ll CP-e TBE ll OCC
FYI its okay to run them after a tune as well, but always best to tune again.
Yeah Dyno tune Belco installed mine no issues, can tell them you know me if u want so they look after you, im scott's cousin (jamie) his the guy with glasses. They did most of the work on my car so they are familiar with MPS cus of this reason. Cheers
Thanks Jimbo. I'll let them know. My internals wont be shipped from Edge for about a month due to a backlog so I'll line it up once they rock up. Good to know that at least one mob in the ACT is decent.