Deleted
Deleted
Last edited by gurusev; 27-07-2013 at 11:15 PM.
anyone??
try araldite?
is that selleys?? I did tried selleys super glue but no success ..
heys guys, I tried fixing it but it didnt work. Anyone can suggest a pro in syd who can fix it..
Glue/Silicone/Plastic weld would only do so much. If it's a concern I would look into buying a new grille. Either aftermarket or genuine.
As for the sideskirt there may be a busted clip or something. You'd have to either take it off or research how it's assembled to understand what's gone wrong.
If you go to Mazda Parts they might have an exploded diagram of how it fits (perhaps?) Then you can think of a permanent solution to fix it in place.
Know any panel beater friends?
Thanks for that, I just used superglue by itself.. Unfortunately, I don't know any panel beaters..
With the grille I would just get a new one as mentioned, relatively cheap online, side skirts are held in place with a press style kind of clip sometimes they become dislodged in the guide rail hence the gap the skirts are easy to remove and inspect
You probably worked out that section comes out, although not very easily so my panel beater told me.
But finding that piece at a wreckers will be tough.
Get a quote from a panel beater. Might scare you into pulling it apart at home, fix, then paint it yourself.
Then you'll know how to get it off next time for a FMIC install
Sent from Samsung Note 2 LTE
Unfortunately my side skirt collected a gutter a little while ago. Fibersports (Based in Taren Point) plasti-weleded it, resprayed it and put all new clips. Really good job
Go to jaycar and buy jb-weld. It's amazing shit! It's a 2 part epoxy mix but it a lot stronger than araldite. I used It to reseat my exhaust flange back in the rear bar after a driveway scrape.