Noob question
Is it possible to remove the exhaust tips from a Gen 2 (2010) ? It looks like it may almost slide off the tail pipes ? I've tried to pull them off without luck.
Noob question
Is it possible to remove the exhaust tips from a Gen 2 (2010) ? It looks like it may almost slide off the tail pipes ? I've tried to pull them off without luck.
off topic ~ I have been looking for nice tips for months but no luck at all :'(
@slixx did some recently.
Sent from my Huge Samsung Note 2
eBay Australia: Buy new & used fashion, electronics & home d I got these.
Note! Gen1's need 2.5' pipe
Last edited by RedDjinn; 10-11-2012 at 07:25 PM.
Snapped by Tangcla - FB Page
Currently RaydTuned
Lots of love from 2XS Racing & Dan's Garage Detailing
Trying to keep it subtle ... | COBB AccessPort | COBB DP | CP-e HPFP | CorkSport TMIC | TurboSmart BPV | Denso ITV22| CorkSport Boost Tubes | SURE Full3 Aeros | SURE REM (Street) | SURE AGS SS Shift Knob | 2XS SSP + SURE CounterShift | Speedline Front Strut Brace | Whiteline RSB | Prima Paint Protection
mine is this one MPS 3 Dual Cat Back Exhaust - Mazda 3 MPS Generation 2 | MPS Garage
so I should get a 2.5" inlet or 3"??
MPS 3 GenII
Achievements
2009 Jamboree Street Compact Winner
Aust. Quickest and Fastest MPS
12.3 seconds @ 111Mph.
Proven over the Qtr mile
Another Mazda 3 MPS - Almost fully bolted - Waiting for a turbo upgrade - The weekend hack.
Toyota Yaris - Coilovers, rollcage, raceseats, harnesses, 18s - Also waiting for a turbo upgrade.
2011 AWD Territory - White and Slightly lowered on 22s - The tow car.
2011 RWD Territory - Black on black and slammed on 22s - The family transporter.
yeah they'll be a tak weld (or two) somewhere at the back. you may need to remove the rear muffler section to access them. 15 seconds with an angle grinder, and they'll slide off. i have no experience with MPS exhaust tips, but most modern cars with tips are like this.