Does anyone have the injector removal slide hammer tool they would like to sell or rent out?
Ideally, before the cup weekend would be great.
Does anyone have the injector removal slide hammer tool they would like to sell or rent out?
Ideally, before the cup weekend would be great.
Did they get stuck? Have you tried removing the crows feet and trying to pull the fuel rail with injectors still attached?
Don't think injector removal tool is always needed, handy though.
Last edited by dazza; 26-10-2012 at 08:58 AM.
Nah... haven't tackled it yet.
Im planning to do it one day over the long weekend along with the TIGs. I wanna be prepared, just in case.
Looking at the DIY on mazdaspeed forums, the injectors look like they're held down by the crow feet brackets and should easily come out with a little twist and a pull.
But im a little concerned about carbon build up between the nozzle and cylinder head, possibly causing them to bond together.
My car has done very little kms so hopefully it wont be an issue.
Anybody???