Install a piece of piss......
BNR S2 in
taken 4.5 hrs so far to fit you you need-
T piece for waste gate and turbo boost line, 50cm size 3-4mm .
30cm long water line, sizes 7.9mm.
heat sheild at back of turbo needs to be modded to fit. Waste gate actuator shaft is little different.
Bottom oil line is 2mm short and needed to be stretched a bit to fit, just make sure when you tightn the bolts up you do them evenly. will check for leaks when i start it
So far so good only have 1-2hrs tomorrow put Tmic, TIP, battery box etc to finish off and hope no problems
http://www.ozmpsclub.com/forum/membe...ts-red-15.html
---------- Post added at 05:29 PM ---------- Previous post was at 05:24 PM ----------
Hardest and longest part of install was teh heatsheild, but this can be left off.. (Check yours) If its left off it will take 4-5 hrs to do install...
---------- Post added at 05:38 PM ---------- Previous post was at 05:29 PM ----------
No need for the restricter, It wont boost as high and as quick but this is not a bad thing until your tuned. On stock tune i logged mine at 14psi, i found power came on smoother.