Hey guys after a TMIC for my 6 MPS.. Would like one > 3" such as ETS or CP-E but let me know.
Darren
Hey guys after a TMIC for my 6 MPS.. Would like one > 3" such as ETS or CP-E but let me know.
Darren
The Cp-e one new is priced quite well, great quality stuff
Newbie FAQ My Build Thread
From stock, to GT3071, to substantially less modded, many lessons learned!
3" HTP | 100 Cel DP | Autotech HPFP | AP V3 - Self Tuned on E20 | JBR RSB | CPE S2 REM | JBR Shifter Bushings
Ezy-Flash Pro - GTX2867R - NPC Clutch/Solid State flywheel - Autotech Fuel Pump Internals - ATP 3" TIP - Cobb SRI - NGK Plugs - CPE FMIC - 2XS Dump Pipe/100 Cel Cat - 3" Custom CatBack Exhaust - TRMotorsport MT1 18x8.5's -Michelin Pilot Super Sports 245/40/18 - DBA Slotted Rottors - Remsa Pads - 60mm Boost Gauge in middle vent - Bilstein B8 - Kings - Turbosmart BOV - emblemless front grill - debadged rear - 2WD Switch
hyperflow?? Locally sourced?
Sent from my GT-I9100 using Tapatalk
Hyperflow too expensive!
more reason to buy from US with high AU dollar!
2004-2010 Upgrade Mazda Mazdaspeed 3 2006-2010 Mazda 6 Intercooler FMIC Kit | eBay
FMIC with 350 dollars delivered :-p
Newbie FAQ My Build Thread
From stock, to GT3071, to substantially less modded, many lessons learned!
3" HTP | 100 Cel DP | Autotech HPFP | AP V3 - Self Tuned on E20 | JBR RSB | CPE S2 REM | JBR Shifter Bushings
. I spoke to the guy. Its EUSA the brand (I ve never heard of this brand). I did some research and I ve read in a couple US forums that its an ok kit. The fins are a bit sensitive though...
There is this one as well eBay Australia: Buy new & used fashion, electronics & home d
there is a HDi kit for the 6 MPS and it has a huge core (FMIC) priced i think just under $900
HDI HYBRID GT2 PRO COMPLETE FRONT MOUNT INTERCOOLER KIT MAZDA 6 MPS - BRAND NEW | eBay
this one you mean?
the same guy has the same kit with 888 dollars as well...
Is it worth it? I mean its just an intercooler. Doesn't get any stress from the engine or anything...
Anyone know of some cheap piping kits to suit a 6?
I've got a hybrid 600x300 fmic, would be nice if there's some povvo chinese cooler pipes to save me some coin :P
Read the instructions for the HDi FM cooler, its dodgy
Read here
Last edited by rogwick; 01-03-2012 at 06:38 PM.
if i was going ebay FMIC for a 6 (non-CPE/corksport/cobb), i would go with the following kit:
05-07 Mazdaspeed6 2.3L intercooler piping + BOV kit | eBay
been used by a few guys in the states...
Last edited by SarcasticOne; 01-03-2012 at 06:42 PM.