Hi all,
Looking for a rear motor mount for a 6. Let me know!
Cheers
Hi all,
Looking for a rear motor mount for a 6. Let me know!
Cheers
I think I still have my stock 6MPS RMM around if that's what you're after?
Otherwise if you want a FAR better aftermarket one, then I'd recommend just getting the Sure. You'd have to be nuts to put the stock RMM back in if you have aftermarket!
I will have a CPE mount for sale in 2 weeks if you're interested.
Sent from my iPhone using Crapatalk
lol...
She's not a big fan, perhaps the 35 week old bun in her tummy isn't helping
Sent from my iPhone using Crapatalk
Hi, please refer to http://www.mpsgarage.com.au/shop/pro...ine-mount.html
Sent from my iPhone using Crapatalk
Ezy-Flash Pro - GTX2867R - NPC Clutch/Solid State flywheel - Autotech Fuel Pump Internals - ATP 3" TIP - Cobb SRI - NGK Plugs - CPE FMIC - 2XS Dump Pipe/100 Cel Cat - 3" Custom CatBack Exhaust - TRMotorsport MT1 18x8.5's -Michelin Pilot Super Sports 245/40/18 - DBA Slotted Rottors - Remsa Pads - 60mm Boost Gauge in middle vent - Bilstein B8 - Kings - Turbosmart BOV - emblemless front grill - debadged rear - 2WD Switch
cpe aftermarket is no chop had one and only lasted a month or 2 but i put out a fair bit of power had one custom made using the casing and urathene i can have one made up using a standard casing just tell me how hard you want it cost is roughly 80 to 100 depending on grade of urathene just send your old mount back once u get the new one