Fark, think I'd better check mine then
Anyone with 75 reported an issue?
i got JBR 75 duro mount and it's fine
oh dear, looks i'll be pulling mine out to check
18 months ago minimum. im going back to the 75d now. works out Ok cause i wanna hit the strip a few times this year, and the 75 will suit better.
---------- Post added at 06:12 PM ---------- Previous post was at 06:08 PM ----------
I dont believe the 75's have failed.
i will add that my mount has copped a fair workout over the last 1 1/2 years. with a day at the drags added in there. I probably should have stuck with the 75 i had the first time around.
I'd definitely get the stage 2 CP-e one, much better design.
Do they offer the new design in different grades of urethane tho? I could only see one on their website.
Only comes in 1 grade. And nobody has it in stock. Plus mine is warranty anyway, so not like Its costing me.
Only one type that I can see
Last edited by Caffeine Fiend; 23-01-2012 at 05:59 PM.
Mine is all good
Sent from my GT-I9100 using Tapatalk
Real glad I decided with the 75 duro now. Decided tougher is better, and vibe-free just means soft. Been pretty happy with it, I'll have mine checked next service.
Now that I think about it some more I remember I also went the 75 to minimize engine movement in a cramped engine bay with 3.5" ETS.
Last edited by Nexus; 23-01-2012 at 06:49 PM.
Got my mount swapped under warranty,
Thank you to MPS Garage for the quick swap over!
Now i really want to pull my Transmission mount out to inspect it. Im not sure if its was just the rear mount gone. Still seem to git a bit more wheel hope than i remember.
If only the side mounts weren't so damn expensive!
Last edited by wyvernone; 14-02-2012 at 12:18 AM.
Can u check the CPE REM without having to remove it from the car ?
Cheers
Not thoroughly. Really need to be removed for a proper check. So both sides of the rubber material can be inspected
Sent from my Galaxy Nexus using Tapatalk