hey guys & gals as the title says after um-ing and ah-ing i decided to chop out the massive $27 and set a set.
the install is not for those short on patience. the paperwork provided say to spray the light itself with lightly soapy water ( and i highly recommend you do )
to manoeuvre the sticker into place, leave to settle then 'squeegee' the excess water out ( i gently used a credit card ) while using a hair drier to heat and slightly shrink the vinyl ( i used a heat gun on low as i have one )
as you slowly heat and manoeuvre it into place it becomes VERY sticky quite quickly, slowly work the air bubbles and small water pockets out.
i recommend leaving a small overhang at the top as when it shrinks it still covers the top of the light, just heat the overhang and carefully tuck over the top
will post headlights as they settle
not sure if ill keep them as yet but either way for less than 30 bucks and an hour of my time it was worth it, even if they only stay on for a week
product links:
VINYL TAIL LIGHT EYELIDS FOR MAZDA 3 & MAZDASPEED 3 | eBay
eBay Australia: Buy new & used fashion, electronics & home d
i did combine postage
comments & thoughts welcomed