User Tag List

Results 1 to 3 of 3

Thread: How did u do it? Audio wire for amps.

  1. #1
    Join Date
    Aug 2009
    Location
    hunter valley
    Posts
    6,403

    Default How did u do it? Audio wire for amps.

    Just wondering how you put a 2/4 gauge amp wire through the flywall? I have done this before but not on my MPS. Ideas guys without drilling a hole..?

  2. #2

    Default

    Drill/pierce a hole through the large rubber grommet where the other wires go.
    There is a very large one behind the glovebox. It is on the drivers side of the battery, below the air duct.
    If you remove the fuse panel (below the glovebox), it's easy to see.
    I ran my 0 gauge wire through there.

  3. #3
    Join Date
    Feb 2010
    Location
    Warranwood, Victoria
    Age
    35
    Posts
    1,546

    Default

    I did the say as Troy but i didn't drill i just fed it through might have to fold the mat back to make it easier. Mine was only 2 gauge so maybe the thickness difference between 0 and 2 made it necessary to drill.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •