Just wondering how you put a 2/4 gauge amp wire through the flywall? I have done this before but not on my MPS. Ideas guys without drilling a hole..?
Just wondering how you put a 2/4 gauge amp wire through the flywall? I have done this before but not on my MPS. Ideas guys without drilling a hole..?
Drill/pierce a hole through the large rubber grommet where the other wires go.
There is a very large one behind the glovebox. It is on the drivers side of the battery, below the air duct.
If you remove the fuse panel (below the glovebox), it's easy to see.
I ran my 0 gauge wire through there.
I did the say as Troy but i didn't drill i just fed it through might have to fold the mat back to make it easier. Mine was only 2 gauge so maybe the thickness difference between 0 and 2 made it necessary to drill.