it works on bose setup? not sure if all 6mps comes with it im still new to this haha
Type: Posts; User: tukangbaso
it works on bose setup? not sure if all 6mps comes with it im still new to this haha
no worries thanks for the input. was thinking of federals at first but ended up with toyos as they were only 30 bucks more a tyre but it seems to wear really quick.
Just wondering rogwick how did you find the FD2s?
Hi,
in my opinion if you're just running normal stuffs optima is overkill as much as i agree it is a good batttery. I used optima in my 4wd as the internal component does not deteriorate from...
if you removed the battery as above you will need to wind it up and hold it for about 3-5secvonds
installed my rear engine mount for mps 6 . CPE 70duro. barely notice any difference which is good as i wanted to keep the comfort level.
happy with it and took me 10mins to install including...
ASG does ecutek which normally locks it if it's tuned.
sounds good. my SRI is still in Chicago getting sorted.. haha
anyone know of a good cut and polisher in perth? or anyone wiling to do a cashie ;P
i bought SRI for my 6. shipment was sent out on the 30th september according to USPS tracking and right now it's still in Chicago sort out facility :idiot2:.
other than took couple days each time...
P0300 is not an idle issue. it is a misfire detected in more than 1 cylinder by the sensors.
air leaks can cause this code so does bad fuel, spark plugs, coil packs. look for cracks in the ceramic...
-10 ltft means youre running rich and ecu is trying to lean it.
Check for air leaks clean out maf. Reset your fuel trim and see if it changes.
So true
oh sorry i meant i was replacing one on a old e30 bmw not retrofit a bmw to a mazda.
You can do actually replace the ball joint on the arms only ONCE. From what i have done genuine BMW part have a marking on the ball joint when you buy it separate to show that it has been replaced...
From what ive read the qfm a1rm for track was the ones squealing due to the harder compound. The qfm hpx that I have doesnt squeal hot or cold. however ive got the trw on the mps 6 and is very...
Used qfm hpx on my old wrx. Very good pads and cheap and little dust. Ended up buying one for my 2006 prado v6 and I feel that its better than bendix. Highly recommend gsl rally sport very quick...
Have you tried cleaning MAF with a proper MAF cleaner?
CRC MAF Sensor Cleaner | Protect and clean Mass Air Flow Sensor
will get rid of dirt / water etc from your MAF
wax and grease remover as above or orange spot goo remover
Sticky Spot & Goo Dissolver | OrangePower.com.au used it on the rex works ok wax and grease remover stinks so bad and i was getting high
thanks for the advice! i've just ordered corksport SRI seems like that's the best first mod and makes it sounds better too then probably a tune after!
same as here.. yeah i'm not saying all of them but a few. It does give a lot of good info and that was how i found Mao who seems to be really good with his evos and wrx wonder how he will go with...
haven't bought one myself but been looking around and if you're in the market for a petrol powered ones Supercheap got them on 30% off. I don't work for them or related to them just a thought after i...
Was on PerthWRX but found most of them a bit on the childish side so i haven't really posted on there seems like a lot more nicer people around here ;)
and as for the 6 over 3 was simply just...
Hi guys, Just bought myself an 06 Mazda 6 MPS. Came out of a WRX 04. Loved the rex to bits but sick of the cheap interior hence i went for the mazda MPS. Almost got a mazda 3 MPS but just like the...