Search:

Type: Posts; User: tukangbaso

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Thread: Aux Cable

    by tukangbaso
    Replies
    4
    Views
    2,799

    it works on bose setup? not sure if all 6mps...

    it works on bose setup? not sure if all 6mps comes with it im still new to this haha
  2. Replies
    7
    Views
    2,585

    no worries thanks for the input. was thinking of...

    no worries thanks for the input. was thinking of federals at first but ended up with toyos as they were only 30 bucks more a tyre but it seems to wear really quick.
  3. Replies
    7
    Views
    2,585

    Just wondering rogwick how did you find the FD2s?

    Just wondering rogwick how did you find the FD2s?
  4. Replies
    2
    Views
    1,202

    Hi, in my opinion if you're just running normal...

    Hi,
    in my opinion if you're just running normal stuffs optima is overkill as much as i agree it is a good batttery. I used optima in my 4wd as the internal component does not deteriorate from...
  5. Replies
    15
    Views
    3,413

    if you removed the battery as above you will need...

    if you removed the battery as above you will need to wind it up and hold it for about 3-5secvonds
  6. Replies
    42
    Views
    13,016

    installed my rear engine mount for mps 6 . CPE...

    installed my rear engine mount for mps 6 . CPE 70duro. barely notice any difference which is good as i wanted to keep the comfort level.
    happy with it and took me 10mins to install including...
  7. ASG does ecutek which normally locks it if it's...

    ASG does ecutek which normally locks it if it's tuned.
  8. Replies
    13
    Views
    4,551

    sounds good. my SRI is still in Chicago getting...

    sounds good. my SRI is still in Chicago getting sorted.. haha
  9. Replies
    1
    Views
    1,850

    cut and polisher

    anyone know of a good cut and polisher in perth? or anyone wiling to do a cashie ;P
  10. Replies
    13
    Views
    4,551

    i bought SRI for my 6. shipment was sent out on...

    i bought SRI for my 6. shipment was sent out on the 30th september according to USPS tracking and right now it's still in Chicago sort out facility :idiot2:.
    other than took couple days each time...
  11. Replies
    24
    Views
    9,962

    P0300 is not an idle issue. it is a misfire...

    P0300 is not an idle issue. it is a misfire detected in more than 1 cylinder by the sensors.
    air leaks can cause this code so does bad fuel, spark plugs, coil packs. look for cracks in the ceramic...
  12. -10 ltft means youre running rich and ecu is...

    -10 ltft means youre running rich and ecu is trying to lean it.

    Check for air leaks clean out maf. Reset your fuel trim and see if it changes.
  13. Replies
    50
    Views
    17,575

    So true

    So true
  14. Replies
    20
    Views
    13,714

    oh sorry i meant i was replacing one on a old e30...

    oh sorry i meant i was replacing one on a old e30 bmw not retrofit a bmw to a mazda.
  15. Replies
    20
    Views
    13,714

    You can do actually replace the ball joint on the...

    You can do actually replace the ball joint on the arms only ONCE. From what i have done genuine BMW part have a marking on the ball joint when you buy it separate to show that it has been replaced...
  16. Thread: Brake pads

    by tukangbaso
    Replies
    34
    Views
    8,539

    [NSW] From what ive read the qfm a1rm for track was the...

    From what ive read the qfm a1rm for track was the ones squealing due to the harder compound. The qfm hpx that I have doesnt squeal hot or cold. however ive got the trw on the mps 6 and is very...
  17. Thread: Brake pads

    by tukangbaso
    Replies
    34
    Views
    8,539

    [NSW] Used qfm hpx on my old wrx. Very good pads and...

    Used qfm hpx on my old wrx. Very good pads and cheap and little dust. Ended up buying one for my 2006 prado v6 and I feel that its better than bendix. Highly recommend gsl rally sport very quick...
  18. Replies
    9
    Views
    4,182

    Have you tried cleaning MAF with a proper MAF...

    Have you tried cleaning MAF with a proper MAF cleaner?
    CRC MAF Sensor Cleaner | Protect and clean Mass Air Flow Sensor
    will get rid of dirt / water etc from your MAF
  19. Replies
    21
    Views
    8,377

    wax and grease remover as above or orange spot...

    wax and grease remover as above or orange spot goo remover
    Sticky Spot & Goo Dissolver | OrangePower.com.au used it on the rex works ok wax and grease remover stinks so bad and i was getting high
  20. Replies
    9
    Views
    2,240

    [WA] thanks for the advice! i've just ordered...

    thanks for the advice! i've just ordered corksport SRI seems like that's the best first mod and makes it sounds better too then probably a tune after!
  21. Replies
    9
    Views
    2,240

    [WA] same as here.. yeah i'm not saying all of them...

    same as here.. yeah i'm not saying all of them but a few. It does give a lot of good info and that was how i found Mao who seems to be really good with his evos and wrx wonder how he will go with...
  22. Replies
    50
    Views
    17,575

    haven't bought one myself but been looking around...

    haven't bought one myself but been looking around and if you're in the market for a petrol powered ones Supercheap got them on 30% off. I don't work for them or related to them just a thought after i...
  23. Replies
    9
    Views
    2,240

    [WA] Was on PerthWRX but found most of them a bit on...

    Was on PerthWRX but found most of them a bit on the childish side so i haven't really posted on there seems like a lot more nicer people around here ;)
    and as for the 6 over 3 was simply just...
  24. Replies
    9
    Views
    2,240

    [WA] [WA] First Mazda ever owned MPS 6

    Hi guys, Just bought myself an 06 Mazda 6 MPS. Came out of a WRX 04. Loved the rex to bits but sick of the cheap interior hence i went for the mazda MPS. Almost got a mazda 3 MPS but just like the...
Results 1 to 24 of 37
Page 1 of 2 1 2