Search:

Type: Posts; User: djKyoto

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    2,341

    Stolen: Red 3 Gen1 MPS

    Hey Guys. Hopko's MPS got nicked last night from his plate (Hills district) (they got his keys).
    Keep an eye out for it. Rego YFC 51J (ACT Plates).
    If spotted or any info email Hopko @ Hotmail.com...
  2. Replies
    40
    Views
    11,200

    Recommendations for the most OEM looking BOV...

    Recommendations for the most OEM looking BOV (that wouldn't be noticeable by insurance etc) that gives a little bit more induction noise. Cheers.
  3. Replies
    17
    Views
    6,084

    Bugatti Veyron on top again...

    Bugatti Veyron on top again

    And it's back again.
  4. Replies
    18
    Views
    3,259

    Can you post a how-to or a link or how to do...

    Can you post a how-to or a link or how to do this? My left foot gets buggered on longer drives.
  5. [NSW] Currently you need to be a VIP member to post in...

    Currently you need to be a VIP member to post in the B&S forum.
  6. Replies
    26
    Views
    18,774

    Donated. :)

    Donated. :)
  7. Replies
    30
    Views
    5,492

    [NSW] I'm usually using the highest gear I can without...

    I'm usually using the highest gear I can without bogging it down.

    I managed to get it to display over 100l/100km accelerating hard in 2nd. Lordy.
  8. Replies
    30
    Views
    5,492

    [NSW] Done 300km, mostly in 60/70kph start/stop...

    Done 300km, mostly in 60/70kph start/stop traffic. Driving like my mum would. Getting 12.7l/100.

    Anyone with a AP want to check my air/fuel ratio?
  9. Replies
    30
    Views
    5,492

    [NSW] Cleaned MAF/IAT, filled the tank with 98 and put...

    Cleaned MAF/IAT, filled the tank with 98 and put a hypertech Flash on the ECU.

    Will see how my economy goes.
  10. Replies
    30
    Views
    5,492

    [NSW] Are the stock TMIC/piping prone to cracks? I...

    Are the stock TMIC/piping prone to cracks? I can't tell if it might be leaking or not since I haven't had the car long. Seems to be fine tho.
  11. Replies
    30
    Views
    5,492

    [NSW] Cleaned out the MAF/IAT today (IAT was pretty...

    Cleaned out the MAF/IAT today (IAT was pretty dark on one side). Air filter was still mostly white so I just gave it a good blow. I do run it on 98. Will report back in a bit if it effects my Avg...
  12. Replies
    30
    Views
    5,492

    [NSW] Great post. Thanks rogwick. Will defo get onto...

    Great post. Thanks rogwick. Will defo get onto some of the above.
  13. Replies
    30
    Views
    5,492

    [NSW] http://sphotos-a.ak.fbcdn.net/hphotos-ak-frc1/8830...

    http://sphotos-a.ak.fbcdn.net/hphotos-ak-frc1/883000_405200139576412_2026186328_o.jpg

    Comes up good after a clean. I'm not a fan of the 14.2l/100km fuel mileage I'm getting tho. :p
  14. Replies
    3
    Views
    1,180

    Upon further inspection I might have found that...

    Upon further inspection I might have found that the noise is probably my backing plate is catching the wheel. Tried to push it in a bit but still causing the sound. Will get it on a hoist later.
  15. Replies
    10
    Views
    5,201

    That DG spoiler looks good. Not sure it's worth...

    That DG spoiler looks good. Not sure it's worth $270+post however.
  16. Replies
    6
    Views
    1,452

    Thread hijack. I have a couple of broken clips...

    Thread hijack. I have a couple of broken clips that hold the plastic trim on the rear bumper (the grey bits around the exhaust). Is there anyway to fix these or would I have to order a new trim part?
  17. Replies
    3
    Views
    1,180

    Yeah I guess you could say that. The rubber bit...

    Yeah I guess you could say that. The rubber bit has split around the balljoint. The rest of the car is fine (had it on a hoist) so I can't see what else would be causing the noise. It actually gets...
  18. Replies
    3
    Views
    1,180

    LCA Balljoint 6MPS

    Hey guys, my Lower Control Arm Ball joint is split (left), which I expect is causing it to make the occasional metal on metal scraping noise as I'm driving along (usually just above 40kph).

    Would...
  19. Replies
    30
    Views
    5,492

    [NSW] SW Syd, 70kms on it. Replaced all four tires on...

    SW Syd, 70kms on it.
    Replaced all four tires on it today. 18 inch wheels aren't cheap... My bank account is a bit sad at the moment haha.
  20. Replies
    30
    Views
    5,492

    [NSW] I just wanted to see if I can replace it as it's...

    I just wanted to see if I can replace it as it's had a small bump on the left rear (visible to the left of the left exhaust pipe), nothing to do with the parking sensors. They're proving very useful...
  21. Replies
    30
    Views
    5,492

    [NSW] I don't need two of them Doug. :p If I wanted...

    I don't need two of them Doug. :p

    If I wanted to replace the outer rear bar (apparently it's just like a 'skin') where would I go? Thanks.
  22. Replies
    0
    Views
    975

    Remote Locking Issue

    Hey guys. Picked up my 6MPS today, but having an issue that I can't figure out (could just be a colossal noob about it all)

    If I lock the car with the fob, the drivers door won't lock (can open...
  23. Replies
    30
    Views
    5,492

    [NSW] http://gergwerk.com/blog/wp-content/uploads/2011/0...

    http://gergwerk.com/blog/wp-content/uploads/2011/05/20090828-good-news-everyone.jpg Good news everyone. Just picked this up. Stock standard with lowish km's.
    ...
  24. Replies
    30
    Views
    5,492

    [NSW] Hunting for a 6 MPS

    Hi everyone. Friend of Hopko's.
    Currently looking around for a Mazda 6 MPS.
    While there are also other cars I'd like (Sportivo/Swift/Colt Ralliart etc), this would be my preferred choice (insurance...
Results 1 to 24 of 54
Page 1 of 3 1 2 3