Search:

Type: Posts; User: JestaT

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    3,796

    15872 This is the seal I'm talking about Green is...

    15872 This is the seal I'm talking about Green is the seal thats leaking apparently I can not get this and have to buy the whole shaft as one part?
  2. Replies
    6
    Views
    3,796

    15872 This is the seal I'm talking about

    15872 This is the seal I'm talking about
  3. Replies
    6
    Views
    3,796

    I was quoted 2700 for the whole shaft from mazda ...

    I was quoted 2700 for the whole shaft from mazda my rear boot is leaking grease but they wont sell the seal separate I need a better solution can anyone help with advice ?
  4. Replies
    7
    Views
    2,236

    Direct Clutch Services in Albion

    Direct Clutch Services in Albion
  5. Replies
    43
    Views
    23,069

    Andy the dule mass flywheel cuts down on engine...

    Andy the dule mass flywheel cuts down on engine vibration that feeds back into the transmission ie makes your ride quiet the down side is it can not be machined so when it wears down it needs to be...
  6. Replies
    10
    Views
    3,625

    Hey guys you were right it is the VVT is it a...

    Hey guys you were right it is the VVT is it a factory fault or something??? anyone know if it will cause damage and where in Brisbane is a good place that has worked on the MPS 6 before??
  7. Replies
    10
    Views
    3,625

    Timing Chain at 74,000k

    Hey guys,

    I have a rattle at start up that sounds like it's getting worse. I believe that the timing chain has come loose at 74,000k anyone else had this problem?? and does anyone know a good...
  8. Replies
    2
    Views
    1,513

    More flow for CAI

    Hey Guys,

    I've been thinking about cutting out the plastic around the bottom left fog light and replacing it with some form of mest to allow more cold air straight to the pod filter which sould be...
  9. Replies
    65
    Views
    13,253

    Get the Evo 10 has my vote better then a rex...

    Get the Evo 10 has my vote better then a rex quicker then an rx8 and 350z is a bit gay when compaired to the EVO mmmmmmmmmmmmmmmmmmmm..........
  10. Replies
    10
    Views
    5,624

    very interesting and I apreciate the info you...

    very interesting and I apreciate the info you have posted great stuff.. it's interesting to see how this system works as it's different to everything else ive seen so far.

    Cheers
  11. Replies
    15
    Views
    2,455

    Hey Tigamica350, Welcome to the site . . ....

    Hey Tigamica350,

    Welcome to the site . . . Enjoy!
  12. Replies
    645
    Views
    270,160

    Sticky: OK Here it is what do you...

    OK Here it is what do you think!http://i365.photobucket.com/albums/oo99/JestaJones/18012009291.jpg
    ------------------------------ Double post merged ------------------------------...
  13. Replies
    22
    Views
    5,617

    Hey mate, I was told there are only one set of...

    Hey mate,

    I was told there are only one set of 19" that would fit (THAT they could find anyway) and they sucked, I'm sure you could find a set some were though, the off set was too low and they...
  14. Replies
    22
    Views
    5,617

    yer the coil overs are out of my price range atm...

    yer the coil overs are out of my price range atm and im getting a good deal on the kings i'll prob just go with them for now. . . . should drop it about 1inch alll round without loosing too much ride...
  15. Replies
    22
    Views
    5,617

    yer i like the style which is what drew me to the...

    yer i like the style which is what drew me to the vizzo's I think these will look just as good and with 18x7.5 I dont think i'll have any rubbing problems Yey! so back to the shop tomorro to have...
  16. Replies
    645
    Views
    270,160

    Sticky: ok the vizzo dont fit so i think im going for...

    ok the vizzo dont fit so i think im going for these http://i365.photobucket.com/albums/oo99/JestaJones/1307200745846846_m.jpg
  17. Replies
    22
    Views
    5,617

    http://i365.photobucket.com/albums/oo99/JestaJones...

    http://i365.photobucket.com/albums/oo99/JestaJones/1307200745846846_m.jpg

    These are the Gmax enigma that im considering now insted 18"x7.5" with the right off set this time I hope! I think they...
  18. Replies
    22
    Views
    5,617

    About to find out !

    Thanks Shin,

    They will be running on 235's ona 36 profile so it's almost the same dimater as the original size only out by a couple of mil so I'll find out tonight as I'm going to pick them up...
  19. Replies
    22
    Views
    5,617

    Thanks man, I went and saw them to day it's...

    Thanks man,

    I went and saw them to day it's actually 19" x 8.5" with a 45+ offset I think they are going to use 36 tyres insted of 40 so 36 will give me a really low profile tyre to make em fit...
  20. Replies
    9
    Views
    2,832

    Whats the stock Turbo Psi

    This may be a dumb question

    Does any one know what the stock psi on the turbo is?? and how much I can tune it up without stressing the motor ?
  21. Replies
    22
    Views
    5,617

    Good point I was having a look at this last night...

    Good point I was having a look at this last night I'm not sure if i have the measurements right correnct me if im wrong but if the standard rims are at 55 it must be negative ? because the rim is...
  22. Replies
    22
    Views
    5,617

    IMG]http://i365.photobucket.com/albums/oo99/JestaJ...

    IMG]http://i365.photobucket.com/albums/oo99/JestaJones/Picture003.jpg[/IMG]

    These are going on next week 19"x8.5" I think the offset is +42
    ------------------------------ Double post merged...
  23. Replies
    31
    Views
    7,997

    sweet thanks guys i'll msg mps garage about...

    sweet thanks guys i'll msg mps garage about getting one sent up
  24. Replies
    22
    Views
    5,617

    the 6 comes with a 55 off-set i was told I could...

    the 6 comes with a 55 off-set i was told I could go 40 without a roll and maybe 36 with some roll work?
  25. Replies
    31
    Views
    7,997

    where did you get a pre filter???

    where did you get a pre filter???
Results 1 to 25 of 71
Page 1 of 3 1 2 3