Search:

Type: Posts; User: shift

Page 1 of 7 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    76
    Views
    42,504

    My CEL goes away when I plug the connector back in

    My CEL goes away when I plug the connector back in
  2. Replies
    76
    Views
    42,504

    turn the car off and plug the connector back in

    turn the car off and plug the connector back in
  3. Replies
    9
    Views
    2,591

    It should be the front one near the headlights,...

    It should be the front one near the headlights, does it have a picture of wipers on the lid?
  4. has the air filter been changed since it was...

    has the air filter been changed since it was first installed? If it has I'd check all the clamps and see if you can tighten any
  5. how does your maf look? was it dirty?

    how does your maf look? was it dirty?
  6. Replies
    51
    Views
    20,468

    A little happy snap that I took at work. Sitting...

    A little happy snap that I took at work.
    Sitting on king super lows with standard shocks, in the process of buying some blitz coilovers
  7. Replies
    14
    Views
    3,386

    I'd look around before i paid that much for that....

    I'd look around before i paid that much for that. Have you checked edgeautosport?
    CPE Cold Air Intake MS3 Gen2 just ask how much shipping would be
  8. Replies
    5
    Views
    1,455

    Apparently the mps ones tend to be noisy, but...

    Apparently the mps ones tend to be noisy, but maybe change the power steering fluids?
  9. Replies
    5
    Views
    1,455

    Could it be your power steering pump?

    Could it be your power steering pump?
  10. Replies
    41
    Views
    18,342

    i got a RHD pod :2thumb:

    i got a RHD pod :2thumb:
  11. Replies
    27
    Views
    5,919

    I think I have the same issue can hear the the...

    I think I have the same issue can hear the the noise in 1st and 2nd at low rpm but once the revs get higher cant hear it because of the intake and exhaust
  12. Replies
    29
    Views
    12,596

    i got socket tool if anyone needs to borrow it...

    i got socket tool if anyone needs to borrow it and I drive my car onto timber blocks then jack it up, hate switching jacks
  13. Thread: Hi im Alex

    by shift
    Replies
    15
    Views
    3,124

    [NSW] Welcome! Not a bad first car, mine was a Mazda...

    Welcome! Not a bad first car, mine was a Mazda rx7 series 4 and I was stupid enough to spend heaps of money on it haha
  14. Replies
    44
    Views
    10,501

    How'd you go? Find the problem?

    How'd you go? Find the problem?
  15. Replies
    29
    Views
    7,654

    ive got federal 595 rs-r's 225/40/18 on my mps6...

    ive got federal 595 rs-r's 225/40/18 on my mps6 and have been one of the best tyres i have ever used
  16. Replies
    21
    Views
    8,833

    i have a full 3" stainless turbo back with a...

    i have a full 3" stainless turbo back with a hi-flow cat and single exit 3" magnaflow muffler and I don't think it's loud at all. Cost me less than $1000 for the full setup as well :cheesy:
  17. Replies
    49
    Views
    13,422

    Buy the long socket with the slot part way down...

    Buy the long socket with the slot part way down the side. Don't get the one that's offset
  18. Replies
    11
    Views
    2,134

    [VIC] Welcome! I can take you for a drive in my 6 if...

    Welcome! I can take you for a drive in my 6 if you haven't been in one :)
  19. Replies
    76
    Views
    42,504

    I got a CEL not on the first start after...

    I got a CEL not on the first start after unplugging but the second and still have it haha
  20. Replies
    28
    Views
    7,751

    I had a 3" down pipe and a hi flow cat on my 6...

    I had a 3" down pipe and a hi flow cat on my 6 plus other mods and when I got it tuned my fuel pump was fine. I do have fuel pump internals in now but I only got them because there was a group buy a...
  21. Replies
    15
    Views
    4,535

    Axspeed6 also did my internals and he did an...

    Axspeed6 also did my internals and he did an amazing job as well! thanks again :y:
  22. Replies
    7
    Views
    2,092

    yeah i'll be there fingers crossed I don't have...

    yeah i'll be there fingers crossed I don't have work
  23. Replies
    7
    Views
    2,092

    I'm in VIC its really soft but it's there ill try...

    I'm in VIC its really soft but it's there ill try get a better video
  24. Replies
    7
    Views
    2,092

    weird whistle/siren type of noise

    Hey just wanted to know if anyone possibly has an idea what could be making this noise. I'm not sure if maybe it's a boost leak or something, but it its pretty quiet and I really only hear it in the...
  25. is the nut just to space it so the shield doesn't...

    is the nut just to space it so the shield doesn't bend and block the cooler on the right side?
Results 1 to 25 of 153
Page 1 of 7 1 2 3 4