Cheers for the update.
Type: Posts; User: GGG
Cheers for the update.
MPS Jim - where did you source yours?
Bum dyno isnt always that accurate. I'd be surprised if it wasnt atleast marginally quicker. You are still with the efficiency range of the turbo.
There is a "diode" trick to get around the CEL.
Offset is low. Make sure the shop allows a try before you buy.
Guard rolling will be a given, fingers crossed no further guard work will be required, it'll be a close call. Dish is good.
Its hard to say.. As much as I would love more power I dont want a) something with a significant increase in "boom" there goes my savings and b) kicks in too much later and hence poor driveability....
MPS6 will be dead in my view (unfortunately).
Not enough historic sales, no offer of auto and the introduction of a new larger 6 in the US with a 3.7l 6 cyl from the CX9 would make hard for them to...
Combination of the above would suck away power (lower bosst etc) but should give you a stutter.
Many km's on the car?
I never got one stutter until I hit 40,000 (still pretty rare for me).
I have a 3cm drop via king springs and can take my car everyhwere (atleast so far).
Ride is bumpier but less bodyroll and less front/back see-sawing with gear changes. Cornering is improved.
If...
Latool - you could always go coilies...lower the beast without too many extra bumps.
RPM2 or Bortex, you wont regret the purchase.
When I am sponging away at the rims with a bucket of water, I just keep reminding myself of the improved driving response.
Enkei's - nice and light - please please please would somebody clean them for me???
18 x 7.5", 50 offset
http://www.mazspace.com/mazspace/d/19940-1/PA180018.JPG
...
Mel - if you dont want to get them rolled I'd stick with 225's, traction difference would be marginal at best for a stock awd car.
Anyone tried Autoexe pads?
I think the spider look is classy but yes...pain the ar*e to clean. I love my Enkei's, especially the improved steering due to the weight saving.
I have the COBB SRI on my MPS6 and I love it but if I could do it again I would have tried the Corksport SRI, inlet pipes is a bonus and they arent cheap, makes sense (from the accountan within....).
Coil-overs (big difference but they are not cheap).
or even a front strut brace (very msall difference but they are relatively cheap and look bling)
Where did you guys source your WOTBOX's from?
All comes down to dollars and ease.
Im an accountant by trade, so I watch my pennies and need something easy coz my fingers were made for calculators (not spanners).
Hence my ETS TMIC: cheap to...
Good to hear! (Bad for me as you have got me thinking again)
What a headache. Feel for ya.
Its one of the reasons I have backed off from a DP. Its the best power mod for the MPS but a PITA. Is the install the same (in terms of ease) with a MPS3? MPS3's seem...
Its a great unit - very popular in the US (have had issue where demand has far exceeded supply). There is a MAF air-straightener or something in the design which has given it a tick of apporval in...