Search:

Type: Posts; User: nath

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    294
    Views
    115,122

    Did you ground to the sub under the passengers...

    Did you ground to the sub under the passengers seat, or the amp under the drivers side? A long way round if you were going to the drivers side!

    Yeah, tried different SD cards, the other slot still...
  2. Replies
    294
    Views
    115,122

    Nice work Mspec, that's great news. No troubles...

    Nice work Mspec, that's great news. No troubles with the help, I'm glad you got it sorted.

    Was the amp hard to pull out? I see the wiring goes through under the carpet - seat out job?

    I'll try...
  3. Replies
    294
    Views
    115,122

    No trouble at all. I guess its better than before...

    No trouble at all. I guess its better than before but not ideal. Pop is much lower on 0 and once the volume is up a bit the whine is harder to hear.
    I'm looking at alternative solutions to the...
  4. Replies
    294
    Views
    115,122

    Yep, and as the RPM's increase the whiz noise...

    Yep, and as the RPM's increase the whiz noise gets higher in frequency. Didn't do it all weekend, nor did the pop. I made a conscious effort to leave it on vol 0 to check.

    Just reading and other...
  5. Replies
    294
    Views
    115,122

    Pulled the head unit out tonight to seat it a bit...

    Pulled the head unit out tonight to seat it a bit better, and since putting it back in I'm now getting engine noise though the speakers and a small pop with Bluetooth when on 0 volume. Tried removing...
  6. Replies
    294
    Views
    115,122

    It's likely that if you have a bose amp you'll...

    It's likely that if you have a bose amp you'll face the pop and loud volume. Others here and in the US have experienced it. I doubt Eonon has done anything to the GM5151 which would stop it.
    ...
  7. Replies
    294
    Views
    115,122

    Instructions to stop bluetooth pop and high volume on low settings

    Finally found a solution to remove the dreaded Bluetooth pop and high volume on low settings on the D5151. Heres how:

    Total Cost: $3 from Jaycar
    Total Time: 30-45 mins

    Likely to void warranty,...
  8. Replies
    294
    Views
    115,122

    Nope and nope. If the re-wiring makes the unit...

    Nope and nope. If the re-wiring makes the unit bearable long term then I might look into the camera.

    For some reason the gps doesn't pickup the sd card anymore, I suspect its the sd slot but...
  9. Replies
    294
    Views
    115,122

    If its anything like the D5151 no, just plugs...

    If its anything like the D5151 no, just plugs into factory harness however from all reading the headunit then supplies the bose amp with a speaker level signal rather than line level.

    I've put up...
  10. Replies
    294
    Views
    115,122

    If anyone is interested in the harness used to...

    If anyone is interested in the harness used to bypass the stock amp shoot me a PM as I no longer have a use for mine. I dont believe you can buy these harnesses any longer.
  11. Replies
    294
    Views
    115,122

    PAC ADD GM24A ADDGM24A Harness TO ADD Replace...

    PAC ADD GM24A ADDGM24A Harness TO ADD Replace Factory GM Bose Amplifiers | eBay was mine.

    I wouldn't be sure where you would start looking to see where you could get the male plug from.
  12. Replies
    294
    Views
    115,122

    Try ebay? I got mine off ebay, not their site.

    Try ebay? I got mine off ebay, not their site.
  13. Replies
    294
    Views
    115,122

    No problems. Took a few weeks to come from the...

    No problems. Took a few weeks to come from the states.

    Here is a few photos of the back of the factory loom. Top row is the wiring which goes to the speakers, bottom row is the wiring from the HU...
  14. Replies
    294
    Views
    115,122

    Would be a viable solution if your using the...

    Would be a viable solution if your using the RCA's from the HU.

    The loom just requires the top and corresponding bottom wire to be connected together, counting back once you figure out which pin...
  15. Replies
    294
    Views
    115,122

    So.. the PAC loom after the modification for the...

    So.. the PAC loom after the modification for the Bose amp bypass worked. Radio volume is now much quieter at 2, and is a more gradual increase.

    The Bluetooth pop is still there when the volume is...
  16. Replies
    294
    Views
    115,122

    Eonon D5151 + Bose = LOUD music...a Solution! -...

    Eonon D5151 + Bose = LOUD music...a Solution! - Mazda3 Forums : The #1 Mazda 3 Forum
  17. Replies
    294
    Views
    115,122

    Wiring loom arrived today to bypass the stock amp...

    Wiring loom arrived today to bypass the stock amp (as shown on American forum). Will wire it up in the coming week and report back with results.
  18. Replies
    294
    Views
    115,122

    Seems odd. There is only one AUX input.. Left,...

    Seems odd. There is only one AUX input.. Left, Right and Video (not used - that's why when you select AUX it says no signal.)

    Double check the plug is plugged and clipped into the old loom...
  19. Replies
    294
    Views
    115,122

    Unpluging the BOSE amp will lose all other...

    Unpluging the BOSE amp will lose all other speakers.. Just need to remove the factory sub from the equation.
  20. Replies
    294
    Views
    115,122

    Assuming the amp is just powering the sub? I'd...

    Assuming the amp is just powering the sub? I'd unplug the factory sub, then use the RCA from the headunit to the amp. Head unit has a Sub gain control in the audio menu. Looks like the unit has 2 sub...
  21. Replies
    294
    Views
    115,122

    Update: Eonon still cannot provide me a solution....

    Update: Eonon still cannot provide me a solution. They have tried the it costs 60 bucks but you pay 40 bucks email to get me to send it back.. and just suggested I do the custom loom on mazda3forums...
  22. Replies
    294
    Views
    115,122

    Coin trick? I didn't need to prop mine up at all...

    Coin trick? I didn't need to prop mine up at all and fits without gaps.
  23. Replies
    294
    Views
    115,122

    Here's hoping. There are some unhappy people over...

    Here's hoping. There are some unhappy people over on the mazda3forums in the US. They should just opensource the interface and let people play.
  24. Replies
    294
    Views
    115,122

    Filename nwd_703? I flashed and it didnt change...

    Filename nwd_703? I flashed and it didnt change anything. Update process took 4 mins.
  25. Replies
    294
    Views
    115,122

    Yep - it requires Bluetooth to be on, which is...

    Yep - it requires Bluetooth to be on, which is somewhat silly though as Bluetooth will autoconnect anyway. I couldn't seem to re-write the NFC like a tag so that I could define my own NFC behaviour....
Results 1 to 25 of 108
Page 1 of 5 1 2 3 4