Quote:
Howdy Sikdailo, welcome to OzMPS.
Looks like you and ScorpMPS will be picking up at the same time next week, albeit in different states. Bet you can't wait!!
New cars are a little different nowadays and can be driven pretty much normally from day dot. As the others have mentioned, don't sit at the same speed all day, keep it varied. You should be fine to open it up a bit when the urge hits you but just keep it sensible.....a short burst here and there, no redlining and no "bouncing off the rev limiter" drag launches.....OK! :spin:
I've had a few new motors built-up over the years and all were actually bedded-in on the dyno before they set foot on the road. That was common practice for many performance / race engine builders. They load them up on the rollers over a couple of hours in a controlled fashion to properly bed in the man bearings and rings. From there on, you just did what you liked....within reason (depending on how long it was intended your motor to last)!! :whistle:
Cheers.....and ENJOY
Definitely no launching.... YET! HAHAHA.