Printable View
all, for those of you that were following, i replaced the L3 in my 07 BK, everythign is running fine though the boost controll valve for some reason isnt functioning, everything is hooked up though my boost goes all the way up over 20psi (guage reading) .
no two stage either in 1st or 2nd, any ideas?
cheers
Make sure the boost control solenoid is hooked up correctly to the wastegate and TIP also make sure the connector is fully seated into the socket
everything's there, everythings hooked up, running the same aftermarket TIP as before.
2 things I can think of off top off head:
1) EBCS is plugged in? So you've actually put the connector into it from the ECU (connector on left side of EBCS in picture below)
2) check the hoses are the same as this:
Attachment 16598
sorted all, Cheers!, after pulling the TIP, i saw a tiny tiny slice through the actuator hot pipe, new hose took an hour to slip in and shes done!
That'll do it :DQuote:
Originally Posted by robbo5121
Glad to hear it's all fixed!