Printable View
This is what I've done:
When Cobb AP arrived today, I attempted to use APR to tune an e85 mix map (1:4 mix)
So using stage 1 CS intake+TIH as a base MAP,
I've adjusted the
1. injector scalars
2. SFGs
3. ignition timings.
Then went to the petrol station to fill up, then flashed afterwards
Have been monitoring KR and fuel pressures and they were good
The car seems faster than before too
Is there anything I'm doing wrong, or anything else that I should be doing as well?
What is your ignition timing set to?
edge, At Load 2.00 they are:
500 1000 1500 2000 2500 3000 3500 4000 4500 5000 5500 6000 6500 7000
-14.00 -11.05 -8.10 -5.14 -0.69 5.26 7.22 8.00 9.00 10.00 11.00 12.00 13.00 14.00
Where did you learn how to tune via ATR?
Rayd,
Mostly from reading threads on MazdaSpeed 3/6 - E85 Fueling - Mazdaspeed Forums
I haven't yet come across a step by step guide on how to tune E85 on ATR, but only gathered info from different inputs/posts, so I'm not sure if I'm doing everything correctly...
This article has been very useful to me so far about using the ATR: Training - Mazdaspeed Forums