So I finally got around to working out how to install these reflectors. They can either replace the existing ones, or can be spliced into the Parker/Brake wiring to behave as they do
I bought them from eBay from Spedline. These are the same ones that MickeyACT bought for his car
Without having to take off the bumper, to remove the original reflectors you need to remove the bolts that support the bumper bar to give it some flex
The reflector screw sits almost flush with the bumper beam support. I found out if you use a shorter screw driver (not a stubby one) you can angle it in
After you remove the screw place pressure on the clip and they pop out
To put the new one in make sure you screw the screw in the reflector first to make a groove. I used a bit of WD-40 in the hole. Once the reflector is in place you should be able to get the screw in no problem
I haven't spliced in the wiring yet into the Parker/Brake light wires, as I'm not too confident to do so. I'll get some help on the weekend
Thanks to MickeyACT & Yeldabr for the help!!
Peter "SLIXX"