So, car has gone back and forward to the repairers, post someone keying the bumper...
Anyhow, first attempt they badly "scoured" the bumper, holograms, fine scratches from too much pressure etc. They fixed it a bit the 2nd time around, not 100% like it was...
Do you have anything that I could do/use without using a machine?
Sorry to hear that about your car mate. You have had a bit of bad luck.
Without a machine, Meguiar's actually have two products that can work well by hand. They both use SMAT which stands for "Super Micro Abrasive Technology". The abrasives in this product are very small and don't break down, unlike DAT (Diminishing Abrasive Technology) that uses larger abrasives that diminish as you work the polish.
Basically, you will be able to get a good level of cut by hand, without scouring the surface with the abrasives. These are the products:
The M105 Ultra Cut Compound has a little bit more bite than the Ultimate Compound, but the Ultimate Compound comes in a smaller size. I would start out by trying the Ultimate Compound. If you are purchasing this product only it might be more benefit to you, to just grab it from a store.
I haven't had any feedback on the SwirlX so I called the Megs hotline for you to see what they have to say about it. They told me it will work similar to the Ultimate Compound but it is a milder product.
They also told me the Ultimate Compound uses some form of fine diminishing abrasives, not like the M105 Ultra Cut Compound. I tried to research it further and found that some claim it is SMAT and other say it is DAT.
Either way, everyone agrees it is good for hand polishing. Since you have a black car it wouldn't hurt to also have the SwirlX on hand to finish with after the Ultimate Compound. Or try with the SwirlX first to see if it has enough bite for what you need.
that would be no problem at all mate. I reckon we could have it fixed up in a matter of minutes
Actually I just had to do a bit of wet sanding on mine yesterday. Only had the front end resprayed a few weeks ago after it was stolen and found that some a-hole had scraped me on the front drivers side guard. Unbelievable.
She is back in all her glory though again now. Might get some pics later!
Im suprised that you have such bad swirl marks in a bumper bar...
Especially after they have had 2 goes at it.
I would like to think if a car came back to have the swirl marks fixed it should be fixed properly the second time. Its a pretty easy fix.
Im also suprised that a bumper bar needed so much buffing that its left such bad swirls in it.
Thanks for the info. The bumper was the place that had the damage to it - It was keyed. I think it was a rushed job - Usually I'm stoked with their work, they let me down massively this time.
I think I've managed to get them all out - I have fluro lights in the garage, and the flood lighting at the Coles Car Park before - seems to have eliminated, but nothing like pure sunlight to tell...
Either way, if they're still there, I'll let Joel have a go at it when Im in Sydney I trust him like I trust his products
2011 Subaru WRX Premium Sedan | 5 MTX | Satin White Pearl | T35 Titanium Tint |
Yeah, Alot of the time they will probably be like 'ahh its only a bumper' and not worry too much.
And to be honest id probably be the same, unless of course its a nice car or an immaculately kept black gen 2. ha.
scoobydoo
Holograms/Swirlies...
CharlieBrown thanked for this post
that would be no problem at all mate. I reckon we could have it fixed up in a matter of minutes
I trust him like I trust his products
LinkBack URL
About LinkBacks
Reply With Quote
