Got a CEL (P2096)

[Jrbris]

supercheap and autobarn now sell maf sensor cleaner ...

[missjody9]

Link to threads about your CEL issues? Also, which codes?

I am using tapatalk so can't do the link thing (or I just don't know how) but I have written things under the Gen two warranty fix post and the consumer laws post and what did you do to your Mazda today. ( hope that helps) and loads of codes different each time they put on computer. Mostly about fuel being lean or running rough.
Today they are replacing the o2 sensor and I told them to clean the maf sensor ( after reading on here that others are doing that)


Sent from somewhere in this big wide world....

[Jrbris]

hope that help jody, i had 1 CEL light due to my new exhaust.. took it to mazda and it''s never come back.... getting tuned soon so that will be intresting.

[missjody9]

hope that help jody, i had 1 CEL light due to my new exhaust.. took it to mazda and it''s never come back.... getting tuned soon so that will be intresting.

Well so far I have no more CEL however this has happened before and a week later it was back so watch this space.


Sent from somewhere in this big wide world....

[Caffeine Fiend]

Fingers crossed Jody


Sent from my iPhone using TapaTalk

[Jmac]

Needed
1x can of electrical contact cleaner
1x can of compressed air
1x phillips head screwdriver
1x flat head screwdriver

1. locate MAF on intake
2. use flat head to remove loom (use it gently under clip to remove)
3. use phillips head to unscrew MAF
4. spray lots of electrical contact cleaner onto MAF sensor (mainly on the 'dirty' side - one side will be black, the other clearish)
5. spray compressed air onto MAF to help dry
6. leave somewhere safe to dry
7. re-install MAF

WHATEVER YOU DO DO NOT DROP THE SENSOR!

[Yeldarb]

Well so far I have no more CEL however this has happened before and a week later it was back so watch this space.


Sent from somewhere in this big wide world....

Double fingers crossed Jody.

[SarcasticOne]

Needed
1x can of electrical contact cleaner
1x can of compressed air
1x phillips head screwdriver
1x flat head screwdriver

1. locate MAF on intake
2. use flat head to remove loom (use it gently under clip to remove)
3. use phillips head to unscrew MAF
4. spray lots of electrical contact cleaner onto MAF sensor (mainly on the 'dirty' side - one side will be black, the other clearish)
5. spray compressed air onto MAF to help dry
6. leave somewhere safe to dry
7. re-install MAF

WHATEVER YOU DO DO NOT DROP THE SENSOR!

also, dont drop screws into engine bay (right jase?)