2xs FMIC + 2xs SRI + CPE 75 Duro mount

[Ski82]

Have just had all these mods installed within the last few weeks, and firstly I must say again an exceptional job by 2xs the man himself, Troy is truely a wealth of knowledge when it comes to these cars, and his products are just that too.....exceptional.
The difference in performance is outstanding, the SRI went on first a couple of weeks back and even without the sound is a nice piece gear and adds great performance as well as looking the part under the hood (2 birds one stone).
The CPE mount went on about a week after that and has settled down now and basically feels normal now, is a little ruff at idle but only when you stop and think about it, but I hardly notice it, and the feel under acceleration makes a world of difference, definatley worth the change to one of these.
The FMIC went on this morning and is the biggest difference to date, and its a massive difference as well, again it looks good is a nice neat install and adds a whole new kick in the pants/wiplash to an already impressive car.
Again just want to thank Troy for his expert fitment and advice, can'[t speak highly enough of him or recommend a better guy for mods for the MPS

Pics to come......
As is the DP


Also Dyno results to come.............

[steinez]

Awesome work!!! Can't wait to see the pics. You're spot on about Troy, wealth of knowledge and awesome with MPS. Had my short shift plate installed bit over a week ago.....whole 2 minutes for Troy. Thinking about the CPE-75 mount as well so good to read your thoughts on this

[Grajy]

Troy is a great guy too...

[CharlieBrown]

Great to hear that you're enjoying the new mods.

Troy does do great work - and has loads of info on the MPS.

[Ski82]

IMG_0416.jpg
This is where it begain.......

IMG_0415.jpg
Now lets get rid of a few things...

IMG_0421.jpg
The man himself at work...Troy.......

IMG_0423.jpg
The FMIC goes in.....

IMG_0424.jpg
Ok so half way there.........

[Ski82]

IMG_0426.jpg
The finsihing touches (pipes) go on......

P1010011.jpg
Finished product.......

P1010014.jpg
One last one for good measure.....

[steinez]

Looks great mate Took a look at the FMIC when I was in the car park earlier this week....very nice work Troy has done for you.