Air filters

[MattMPS3]

Yeah it was OK, I cant really say there was any noticeable difference between the one that was supplied with the CAI, a K&N or this one, I did have the cp-e water repellent cover over the filter, which was a very fine mesh, so would have only helped filtration, CAI filters see quite a bit of dirt.
The results of the test in the review is based on pushing a lot of these filters to their extreme limits, I cant see an MPS out flowing any 3" pod filter, although I have seen some pretty dicey filters, avoid the cheap wire mesh filters, they might flow well, but its only because they are so poorly manufactured that grains of sand could easily pass through them.
I found the 3A for about $20 after a few minutes of google time, I didn't really buy it as a main filter, it was more of a spare for when I was cleaning the other filter, although more often that not I couldn't be bothered pulling the car back to bits to swap them back so it would stay on.

[Doug_MPS6]

Mine is a large K&N pancake filter where the old TMIC used to be. No-replacements required, just a wash when it gets dirty, which hasn't happened yet, and then re-oil with K&N oil.

[toine888]

Yeah it was OK, I cant really say there was any noticeable difference between the one that was supplied with the CAI, a K&N or this one, I did have the cp-e water repellent cover over the filter, which was a very fine mesh, so would have only helped filtration, CAI filters see quite a bit of dirt.
The results of the test in the review is based on pushing a lot of these filters to their extreme limits, I cant see an MPS out flowing any 3" pod filter, although I have seen some pretty dicey filters, avoid the cheap wire mesh filters, they might flow well, but its only because they are so poorly manufactured that grains of sand could easily pass through them.
I found the 3A for about $20 after a few minutes of google time, I didn't really buy it as a main filter, it was more of a spare for when I was cleaning the other filter, although more often that not I couldn't be bothered pulling the car back to bits to swap them back so it would stay on.

Thanks for that, well I bit the bullet and just bought one, even though it looked very similar to the cheap Bursons one i had on in replacement of the K&N that split.
On first drive it seems similar to the bursons one in induction etc, but im hoping it will filter more out, as the Bursons one was $17 and a no brander. So yeah im sure it will do for now.

I did however by some MAF cleaner and cleaned my MAF IAT whatever its called, and wow that made such a differnce, car is driving like how i remember.
Next will be Hypertech or COBB AP i think.

Thanks again for your opinion Matt

[Jmac]

Thanks for that, well I bit the bullet and just bought one, even though it looked very similar to the cheap Bursons one i had on in replacement of the K&N that split.
On first drive it seems similar to the bursons one in induction etc, but im hoping it will filter more out, as the Bursons one was $17 and a no brander. So yeah im sure it will do for now.

I did however by some MAF cleaner and cleaned my MAF IAT whatever its called, and wow that made such a differnce, car is driving like how i remember.
Next will be Hypertech or COBB AP i think.

Thanks again for your opinion Matt

Where from

[toine888]

Where from

There is a place in Melbourne called East Coast Autos
These 3A Racing pods are however also available on ebay shops

[Jmac]

tanks

[Jmac]

I'm having issues sourcing k&n ru4450 filter.
Apparently the pg intake used 2.75 sized filters help!?

Sent from my GT-I9100 using Tapatalk

[Jmac]

Managed to order off eBay from the uk

Sent from my GT-I9100 using Tapatalk