Turbosmart dual port bov flutterdump??

[thelegend64]

Hi all, anyone else out there running a turbosmart dual port bov running 50/50 get an aweful case of flutterdump on anything but full boost? I have tried adjusting it from full hard to full soft and it makes no difference. At the time of install I also changed the vacuum and return line for aftermarket items also, could the vacuum line be the cause? Any ideas?

[thelegend64]

Bump/anyone?

[Victa]

I had one on my 6 for a few months... even tightened right down I got no flutter.

Chris.

[rayd]

i'd love this setup! lol full boost VTA + Re-circ and below full boost (<12psi) flutter, wicked!

i'll swap my turbosmart dual port with you if you dont want it :P

[Nirvandan]

Do you run a FMIC?....i never used to get flutter until the FMIC went in.

[thelegend64]

Rayd, do you get flutter or flutterdump? Also not running a FMIC. Chris did you change the vacuum line to an aftermarket version?

[rayd]

Rayd, do you get flutter or flutterdump? Also not running a FMIC. Chris did you change the vacuum line to an aftermarket version?

arnt they both the same?

[MPS2NV]

Mine hasen't been an issue, sometimes flutters, same VTA or 50 50.

---------- Post added at 11:20 AM ---------- Previous post was at 11:16 AM ----------

I understand that there is other springs available for the Dual port TS bov, maybe suss that out?

[thelegend64]

Flutterdump is when it flutters for a second then blows-off, sounds pretty silly. I am starting to think they sent me the wrong spring?

[rayd]

oh , yer mine does that on minimal boost, say anything under 5psi... i like it