Help needed with rear sway bar torque settings

[STEALTH_MPS]

Hey guys. Had a quick look around in the forum but not much i could find.

Just curious as to what the torque setting are for the bushing bracket bolts , the end links & also the plate that you take off to gain access to the rear sway bar.

Sorry if it has been posted elsewhere. Any help appreciated.

Chris

[MattMPS3]

Hey Chris,

Is this what you are after,



Have you fitted the coilovers yet ??

[STEALTH_MPS]

Thanks matt although would the settings be the same for all types of sway bars that you put in? I installed the hotchkis one on the stiffest setting.

Nah haven't installed them yet. They'll be going in as soon as i get back from overseas in june. No money atm to do it.

[MattMPS3]

Yeah, bolt torque settings shouldn't vary between parts, I dont think I even used a torque wrench when I installed mine.

Get your coil overs done by the guys at East Coast, they did a great job fitting my H&Rs, was about 550 fitted, height set & wheel alignment. They make a huge difference to the car.