yea put me as a maybe too thanx
yea put me as a maybe too thanx
Im in for a set
probably a dumb question, but how much life can you expect out of these?
because my bonnet is open for a minimum 14 hours each day
14 hours do u leave it in the garage overnight with the bonnet open ?
Have these been tested for the MPS6?
On MPS Garage's website, under Mazda 6 MPS > Engine, the hood dampers are under there, so i'm assuming that they fit the car.
Yes they fit MPS3, MPS6 & both Mazda3 / 6.
Dooo it! bonnet lifters are cool!
put me down for a maybe.
Fark, there not bad. . Col should get a set so I can see what mods are required to make them fit on my R
cmon guys 5 + i want these ansd the 20% off
haha. we have 3 so far. and a few maybes. Just gotta win them over
Hmm maybe.. If I have the funds for it...
If I get it whos going to install it for me
Same boat here betty... Not that I'm lazy or anything.....
If it's guaranteed to fit first time, or my money back, you can include me.
Thanks Tone.
Ok. so far 4 of us. would I be able to get the car make you have just to update the list a little.
I think I'll be in the same boat as kmh001. Also if the shipping is cheap ^_^
If so count me in
hey rfzd. Ill organise the shipping via my company so shipping shouldnt be a problem. I'm sure MPS garage can guarantee that these bad boys will fit first time without any problems. Right?
Or you need to do is remove four bolts, fit the ball joints & then the strut.
It will take about five minutes no more then that.
Or most as easy as filling up your car.