Flash tunes and torque restrictions on the MPS3

[Bakis]

With the Mazedit tune there is very little drop off top end I pulled hard to 6200 then is flattens, feeling wise it doesn't lose much but Dyno graph wise it says it does, my tyres say otherwise...

Grajy is in another league due to FMIC and full DP his peak is higher and would pull harder and high rpm.

[luke 3mps]

Cpe fuel and throttle flash can do teh same thing for $850, chat to MPSG they will send it away and will come back to what u wanted. mine has all restrictions gone. Is controled by the standback .

MPSG have a tuning solution like the mazdaedit, ecutek, chip torque. I think off memory its cheap..

All these tunes give good results

[2XS]

The SWAS can't be removed or altered via the ECU. You can unplug it though if you don't want it.

The torque limiters can be set wherever you want. It is set as a % per gear.
From memory:
1st: 85%
2nd: 90%
3rd: 95%
4th:100%

[Grajy]

With the Mazedit tune there is very little drop off top end I pulled hard to 6200 then is flattens, feeling wise it doesn't lose much but Dyno graph wise it says it does, my tyres say otherwise...

Grajy is in another league due to FMIC and full DP his peak is higher and would pull harder and high rpm.

I make peak at about 6000rpm. Then, it slowly drops off to the 6500 cut off. I have no limiters, pulls 17.5psi to cut out, and runs rich. My exhaust gets filled with fuel so much, that when I punch it hard into the next gear, I get a huge BANG backfire from the exhaust on lift-off.
I haven't used the other tuners, only HP-F. And as a mechanic, my tune suits me. I'm confident I will NEVER blow the engine due to tuning. Remember, run it rich! NEVER lean, even on lift-off...!

[Bakis]

I make peak at about 6000rpm. Then, it slowly drops off to the 6500 cut off. I have no limiters, pulls 17.5psi to cut out, and runs rich. My exhaust gets filled with fuel so much, that when I punch it hard into the next gear, I get a huge BANG backfire from the exhaust on lift-off.
I haven't used the other tuners, only HP-F. And as a mechanic, my tune suits me. I'm confident I will NEVER blow the engine due to tuning. Remember, run it rich! NEVER lean, even on lift-off...!

Hmm maybe mine makes peak at 5700 but anyway i love the bang on gear changes not as good as the HSV VXR's pops and crackles but still very entertaining lol.

[Grajy]

Hmm maybe mine makes peak at 5700 but anyway i love the bang on gear changes not as good as the HSV VXR's pops and crackles but still very entertaining lol.

You get bang too??? Awesome.

[Bakis]

Yeah but since I still got top half of standard dump bang isn't all the time lol. I think cause the top cat is still there on the standard dump so once i get around to that should sound similar to yours

[Grajy]

Bang FTW!!!
lol

[Chris at Tunehouse]

Calling all flash tuners;

What control do you have over the torque restrictions applied against the gear, and SWAS (Steering Wheel Angle Sensor) input?

I'd be keen to see the restrictions removed from the point of view of what gear I'm in (I'm quite capable of modulating throttle input to avoid traction loss), and re-tuning of the restrictions imposed based on readings from the SWAS.

My car has wider wheels, sticky tyres, upgraded springs and shocks and is well and truly capable of putting down more power than the factory ecu is allowing. That said, complete removal of the restriction applied from the SWAS is not what I'm after. I just want it tuned to the handling characteristics of my individual car.

Keen to hear from anyone who has discussed this with their flash tuner, and of course from any tuners themselves who know what they're talking about

Hi Guys!

Scaredycrow, yes we can modify / remove the torque limiting for both the gear selection and steering input... No drama at all! We have complete control in this regard and have tuned many with great results and plenty of happy clients!

Let me know if there is any extra info you're after - Always happy to help!

Kind Regards
Chris Milne
Tunehouse
e: chris@tunehouse.com.au
w: www.tunehouse.com.au
p: (02) 9557 4000

[Scaredycrow]

Hi Guys!

Scaredycrow, yes we can modify / remove the torque limiting for both the gear selection and steering input... No drama at all! We have complete control in this regard and have tuned many with great results and plenty of happy clients!

Let me know if there is any extra info you're after - Always happy to help!

Kind Regards
Chris Milne
Tunehouse
e: chris@tunehouse.com.au
w: www.tunehouse.com.au
p: (02) 9557 4000

Legend. Thanks Chris.